View Single Post
Old 12-23-2005, 12:00 PM   #3
Claudemir Bonfim Claudemir Bonfim is offline
Juried Member
PT Professional
 
Claudemir Bonfim's Avatar
 
Joined: May 2004
Location: Americana, Brazil
Posts: 1,042
Send a message via MSN to Claudemir Bonfim
santa

Recently, Mr. Whitaker emailed me about the subject and gave me the following tips:
  • 1. Wrap your linen around your stretcher bars - not too tight - and staple the linen to the bars, about every four inches or so. This is temporary!
  • 2. Brush on a coat of acrylic medium - whatever brand you prefer - Winsor&Newton or whatever.
  • 3. After that clear coat dries, sand it lightly with fine sandpaper.
  • 4. Doesn't hurt to brush on a second coat, and sand again, but not absolutely necessary to apply two coats.
  • 5. Brush on two or three coats of acrylic gesso - thinned to the consistency of milk or cream. Sand between coats.
  • 6. Notice that traditional canvases primed with flake white are relatively smooth - not too much weave showing. You want to fill your canvas with enough gesso coats to fill a lot of the canvas weave. Do this to personal taste.
  • 7. When the canvas is dry, restretch it drum tight. Some folks play a hand-held hair dryer on the back of the canvas while they stretch. A canvas stretched dry will keep from getting slack much better than a canvas full of humidity.

Hope it helps.
__________________
Bonfim
[email protected]
  Reply With Quote